Tiffany Gloss Car Wrap | Polymeric Vinyl

Regular price $150.00 USD
Size: 1.52*6m(5*20ft)
Color: Tiffany

💪 Hurry up! Only 9 left

Tiffany Gloss Car Wrap | Polymeric Vinyl
$150.00 USD
1.52*6m(5*20ft) / Tiffany

Tiffany is that calm robin-egg blue with a touch of green, the kind of shade that turns heads without shouting. Under the gloss finish it reads soft and clean in shade, then lifts and brightens the second sunlight hits it. It is a color that feels custom and a little nostalgic at the same time, perfect if you want something fresh that almost no one else on the road is running.

This is a real color change in polymeric gloss vinyl, not paint and not a film you spray on. It lays down with a wet, mirror-smooth shine and wraps tight around mirrors, handles, and body lines. While it gives your car the new look, it also sits over your factory paint and takes the daily hits of sun, dust, light scratches, and road grime so the original finish underneath stays protected.

Side by side comparison of a car finished in Tiffany gloss vinyl wrap versus a Tiffany respray, showing the wrap matches the painted look.

Key features

  • Painted-on gloss finish: a mirror-gloss topcoat gives the deep wet-paint shine without the cost of a respray.
  • Air-release adhesive: built-in air channels push bubbles out, so the film lays flat and you can reposition as you work.
  • Conforms to curves: the polymeric PVC stretches over mirrors, bumpers and body lines for a smooth, seamless wrap.
  • Protects the paint underneath: the wrap takes the daily wear while your factory paint stays sealed and original.
  • Removable: peels off cleanly later with heat, so you can change the look or go back to stock.
  • UV and weather resistant: the gloss topcoat holds up to sun and rain across a -30 to +140 degree range.
  • Easy to keep clean: wipes down and washes like paint, with no special care needed.

How a wrapteck gloss wrap is built

Layer diagram of Tiffany gloss vinyl wrap showing the PVC gloss face, air-release acrylic adhesive, and PET liner.

Specifications

Material Polymeric PVC vinyl
Finish Gloss
Face film thickness 3.7 to 4.1mil
PVC face film 90 micron
Adhesive Henkel solvent-based acrylic, air-release
Adhesive thickness 1.6mil
Release liner PET plastic, 75 micron
Heat resistance -30 to +140°C
Roll width 1.52m (5ft)
Roll lengths 6m, 18m and 23m
Application Dry or wet install

New to wrapping?

If this is your first wrap, start with our guide on how to wrap a car. The air-release adhesive makes panels and accents very DIY friendly, and a professional installer is the safest route for a full-car wrap.

Frequently asked questions

How long does a Tiffany gloss wrap last?

With normal care a Tiffany gloss wrap holds its shine and color for years. The film is built to take sun, rain, and daily driving, and a car that lives in a garage or under cover will keep that clean blue-green looking fresh even longer. Wash it regularly and keep it out of harsh chemicals and it will reward you.

Will the wrap damage or protect my paint?

It protects it. The Tiffany vinyl sits on top of your factory paint and takes the daily wear instead, the sun, the grit, the light surface scratches. When you apply it to clean, undamaged factory paint and remove it properly, the original finish underneath comes back out looking the way it went in.

How is a Tiffany gloss wrap different from a respray?

A respray in Tiffany is permanent, takes days in a body shop, and costs a lot more. This wrap gives you the same painted, glossy blue-green look for less, goes on far faster, and peels off later if you want to go back to your original color or try something new. Your factory paint stays untouched the whole time.

How much film do I need for my car?

The rolls are 1.52m wide, which is about 5 feet, and come in 6m, 18m, and 23m lengths. A small car or a set of accent panels usually works with the shorter roll, while most full sedans and SUVs land around the 18m length. If you are wrapping a larger vehicle or want extra film for mistakes and complex curves, go with 23m. When in doubt, size up so you are not short mid-job.

Can I install Tiffany gloss myself?

Yes. The film uses a Henkel solvent-based acrylic adhesive with air-release channels, so you can push trapped air out to the edge instead of fighting bubbles. You can run a dry install or a wet install depending on what you are comfortable with. Take your time on the curves, use heat to set it, and a patient first-timer can get a clean result on flatter panels.

Does the Tiffany wrap come off cleanly?

It does, when it is removed the right way. Warm the film with a little heat and peel it back slow and steady at a low angle. On healthy factory paint it lifts off without taking the finish with it. That clean removal is the whole point of a wrap, you get the Tiffany look now and keep your options open later.

How do I wash and care for the gloss finish?

Treat it like good paint. Hand wash with a soft mitt and a gentle car shampoo, rinse well, and dry with a clean microfiber so you do not leave water spots on the gloss. Skip harsh solvents and aggressive automatic brushes. Wipe off bird droppings, fuel splashes, and bug splatter quickly so they do not sit on the surface.

Will the Tiffany color fade over time?

The film is made to resist fading and hold that soft blue-green through sun and weather, rated to handle temperatures from -30 to +140 C. Like any finish it lasts longest with care, so regular washing and garage or shade parking will keep the gloss and the color looking their best for the long haul.

  • Free Shipping

  • Secure payment

  • Contact our experts

  • Free Returns