Light black gloss is the subtlest shade in the smoked headlight range. In direct sunlight the lens takes on a faint grey tint that gives your car a cleaner, more aggressive look without going full blackout. At night the smoked effect becomes almost invisible, keeping your headlight beam visible and the car looking stock from a distance.

Any tint film will reduce some light transmission. The light black shade is intentionally mild, so the reduction is minimal compared to darker options. For daily driving most owners find it acceptable, but if you do a lot of night driving on unlit roads, it's worth testing one headlight first to see how you feel about the output before doing both.

This is a PVC vinyl tint film. Its job is to add a smoked appearance to your headlight lens. It does include a rock chip resistant face film that provides light surface protection, but the primary purpose is the visual darkening effect, not clear surface protection.

Clean the headlight lens thoroughly with isopropyl alcohol and let it dry. Cut your piece slightly larger than the lens, peel back the liner, and lay the film onto the lens. Because the adhesive is repositionable, you can lift and reposition it until you're happy with the alignment. Use a squeegee to push out air bubbles, then use a heat gun on a low setting to help the film conform around curved edges. Trim any overhang with a sharp knife.

Warm the film gently with a heat gun to soften the adhesive, then peel from one corner at a slow, steady angle. On a clean, undamaged headlight lens the adhesive releases without leaving residue. If any adhesive spots remain, a small amount of isopropyl alcohol on a microfibre cloth cleans them up easily.

The film is designed to reduce shrinkage and light peeling, which are the two main reasons a gloss finish can look uneven after install. Using moderate heat while conforming the film around tight curves helps the material relax into position without stress marks. Taking your time during the squeegee and heating steps makes the biggest difference in getting a factory-smooth result.

With a proper clean install on a sound lens the UV resistant face film holds its gloss finish for a good stretch of daily driving. How long exactly depends on your climate, how much direct sun the car sits in, and how often it goes through automatic washes. Vinyl headlight tint is a budget-friendly option precisely because replacing it when it eventually wears is quick and inexpensive compared to a respray.

Yes. The film works on any smooth plastic or polycarbonate lens. Taillights and fog lights are common applications. Just make sure the surface is clean and free of cracks or chips before you apply, since the adhesive needs a smooth base to bond evenly and release cleanly later.