Flame Orange Super Gloss Car Wrap | Polymeric Vinyl

Regular price $180.00 USD
Size: 1.52*6m(5*20ft)
Color: Flame Orange

🎉 Free Shipping! Ready to ship

Flame Orange Super Gloss Car Wrap | Polymeric Vinyl
$180.00 USD
1.52*6m(5*20ft) / Flame Orange

Flame Orange is loud in the best way. It throws a hot, saturated orange under sunlight and deepens into a rich molten tone in the shade, the kind of color that turns a parked car into a head-turner. The high-gloss surface reflects light like fresh paint, so the body lines on your hood, roof and panels read sharp and clean from across the lot.

This is a color wrap, not just a sticker. The film lays a smooth glossy skin over your existing paint, giving you that sprayed-on orange finish while the factory coat stays sealed underneath against road grime, light scuffs and sun exposure. When you want a change, it comes off and your original paint is still there.

Side-by-side of a car in Flame Orange gloss vinyl wrap versus the same car after a Flame Orange respray, showing the wrap matches the painted look.

Key features

  • Painted-on gloss finish: a mirror-gloss topcoat gives the deep wet-paint shine without the cost of a respray.
  • Air-release adhesive: built-in air channels push bubbles out, so the film lays flat and you can reposition as you work.
  • Conforms to curves: the polymeric PVC stretches over mirrors, bumpers and body lines for a smooth, seamless wrap.
  • Protects the paint underneath: the wrap takes the daily wear while your factory paint stays sealed and original.
  • Removable: peels off cleanly later with heat, so you can change the look or go back to stock.
  • UV and weather resistant: the gloss topcoat holds up to sun and rain across a -30 to +140 degree range.
  • Easy to keep clean: wipes down and washes like paint, with no special care needed.

How a wrapteck gloss wrap is built

Cross-section diagram of Flame Orange gloss vinyl showing the PVC color face, air-release acrylic adhesive layer and PET liner.

Specifications

Material Polymeric PVC vinyl
Finish Gloss
Face film thickness 3.7 to 4.1mil
PVC face film 90 micron
Adhesive Henkel solvent-based acrylic, air-release
Adhesive thickness 1.6mil
Release liner PET plastic, 75 micron
Heat resistance -30 to +140°C
Roll width 1.52m (5ft)
Roll lengths 6m, 18m and 23m
Application Dry or wet install

New to wrapping?

If this is your first wrap, start with our guide on how to wrap a car. The air-release adhesive makes panels and accents very DIY friendly, and a professional installer is the safest route for a full-car wrap.

Frequently asked questions

How long does a Flame Orange gloss wrap last?

With normal care it holds its gloss and color for years. Bright oranges like this one love a garage, since steady shade and less UV keep the finish punchy for longer. Wash it gently, keep it out of harsh sun when you can, and Flame Orange stays vivid well past the first few seasons.

Will this wrap damage or protect my paint?

It protects it. The Flame Orange film sits on top of your factory paint and takes the daily hits instead, light scuffs, road film, bird droppings and sun. Your original paint stays sealed and clean underneath. This is a cosmetic gloss wrap, so it is not rock-chip armor like paint protection film, but for everyday wear it acts as a shield.

Flame Orange wrap or a respray, which makes more sense?

A wrap gets you this orange for a lot less than a quality paint job, and it is reversible. A respray is permanent and can hurt resale if a buyer wants the original color. With Flame Orange vinyl you get the painted-on gloss look, you keep your factory paint safe under it, and you can return the car to stock later. It is also faster to apply than booking a full repaint.

How much film do I need for my car?

The roll is 1.52m wide (5ft) and comes in 6m, 18m and 23m lengths. As a rough guide, a small car or partial job suits the 18m roll, while most full-size sedans and SUVs need the 23m roll to cover the whole body with extra for door jambs, mirrors and mistakes. The 6m length is handy for accents like the roof, hood or trim. Measure your panels and add a margin before you order.

Can I install Flame Orange myself?

Yes. The Henkel solvent-based acrylic adhesive is air-release, so the channels let trapped air escape and help you slide the film into place instead of fighting bubbles. You can go dry or wet install. Flat and gently curved panels are very DIY-friendly. Bumpers and deep curves take patience and a little heat, so take your time on those.

Does the wrap come off cleanly later?

It does. When you are ready for a change, warm the Flame Orange film with a heat gun and peel it back at a low angle. The adhesive is built to release without tearing up your paint. Any light residue wipes away with adhesive remover, leaving the factory finish underneath ready to go.

How do I wash and care for Flame Orange gloss?

Hand washing is best. Use a soft mitt, a pH-neutral car shampoo and two buckets, then dry with a clean microfiber towel. Skip harsh brushes and aggressive automatic car washes. Knock off bird droppings and bug splatter quickly so they do not sit on the gloss. Park in shade or a garage when you can to keep the orange bright.

Does the gloss fade over time?

Flame Orange is built to hold its shine, and the film handles real-world temperatures from -30 to +140 C. Like any bright color exposed to constant sun, long unprotected UV is the main thing that dulls a finish over the years. Regular gentle washing and garage parking keep the gloss and the orange depth looking fresh.

  • Free Shipping

  • Secure payment

  • Contact our experts

  • Free Returns