It lays a solid, deep blue color across the entire lens. The shade stays consistent whether the headlights are off or on, giving the front end a clean monochrome look rather than a subtle tint.

Yes, any colored tint film will reduce some light output through the lens. Blue is a deeper tint, so you should check local road regulations before driving on public roads with it applied. Many buyers use it for show builds, car meets, or track days.

Yes in a few meaningful ways. TPU is significantly more elastic, so it conforms around tight curves and compound shapes without lifting at the edges. It also absorbs low-speed debris impact rather than cracking or tearing, and it removes without leaving adhesive residue the way some vinyl films can.

Use the wet-stick method: clean the lens thoroughly, mist the surface with a slip solution (water with a drop of dish soap works), position the film, then squeegee from the center outward to remove water and air. The film is repositionable while wet, so you can lift and realign before it sets.

It is designed for both DIY and professional use. The repositionable adhesive gives you time to adjust during the wet install, which makes it more forgiving than dry-apply films. Headlights with flatter lens shapes are easier for first-timers; heavily contoured housings take a bit more patience.

Warm the film gently with a heat gun or hair dryer to soften the adhesive, then peel from one corner at a low angle. The repositionable acrylic adhesive is formulated to release cleanly, leaving no sticky residue on the headlight lens.

No. The adhesive on this film is specifically a repositionable acrylic formula that releases without transferring glue to the lens surface. A clean peel leaves the housing exactly as it was before.

Yes. The same TPU headlight tint is available in Light Black, Black, Grey, Light Grey, Orange, Viper Green, Green, and Yellow. Because removal is residue-free, swapping colors is straightforward when you want a change.